SOHC.co.uk Forums > CB350/400

Rear exhuast mounting bolt size question?

<< < (2/2)

SeanFD:
Hi All,

Back after a long delay to try and complete the rebuild of Rusty. Since I last posted, I think I have been to Zimbabwe to sell and pack up my house, to Netherlands to visit my son, to France to try to rent and eventually buy - renting was impossible – a flat for my son at Uni in Montpellier and finally a house for myself in a little village called St Ferriol - passers by welcome for a cup/glass of whatever is available. I have also been back to Ireland a couple of times, oh yes, and I also acquired a 1970 T120 Bonnie!

I'm following this thread with interest as, a few months back, I got my hands on a complete Motad system and am about to try mounting it. I don't know what bits I took off; about to go and look just now.

What parts manual are your using Deano? Mine stops at No 525, and doesn't have any schema for teh silencer mounting.

Can you post the schema again, because I only can see a small version and its not legible.

Cheers

Deano400:
The copy of the manual that shows the silencer mounting is not great quality but is usable.
Hopefully it will upload.
Maybe someone with the knowhow can add it to Aladdin's Cave.
[ Guests cannot view attachments ]

SeanFD:
Thanks for that; mine stops at the L/M page. It's a pity the serial numbers are so hard to read, but at least now I can see what parts I should have.

This may have been better on Ted's other post: http://www.sohc.co.uk/index.php/topic,27301.0.html, but...

I found this bracket came with my exhaust system:

[ Guests cannot view attachments ]

which looks like the one Ted has.

I am guessing it goes on something like this:

[ Guests cannot view attachments ]

and then attaches using just one bolt.

Navigation

[0] Message Index

[*] Previous page