SOHC.co.uk Forums > CB350/400
400 wiring loom route question?
Laverdaroo:
Well thankfully she's no longer in such a poor state, it looked worse than what it was. tbh.
Lobo:
Does this help?
McCabe-Thiele (Ted):
Well that's interesting the schematic diagram shows the loom going over the left coil whereas Roos stays under the frame thereby using the frame clip I have behind the coil.
Could it be they changed the wiring route due to heat issues from the engine?
Roos coil wiring is like mine was at the top of the frame.
Update: I have moved my loom back again so it is using the frame clip & is under the coil unit. This move has had a positive side effect in that it pushes the whole loom slightly forwards so where it branches at the front the wiring connectors in the pod are not as inclined to protrude from the end of the cover.
There is a metal section that is shaped like the ones that carry the solenoid & flasher unit - it appears to have no real function unless there is something missing?
PS Some of the cable ties in the photo are temporary.
wiring pic by Macabe Thiele, on Flickr
smoothoperator:
Looks very neat Ted. I'll bet lots of 400's have the loom under the coils. Mine was. However I have routed as per the diagram above them, let's see how it goes.
taysidedragon:
The bracket sticking out under the wiring bundle is for a speed control unit not fitted in most markets.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version