SOHC.co.uk Forums > CB500/550

fuel pipe check ..... 950013500160M

<< < (4/6) > >>

SPR:

--- Quote from: Bryanj on October 01, 2022, 05:21:53 PM ---Undo the locking screw on the outside, remove the fork piece on the inside and the complete mechanism comes out from the inside

--- End quote ---

Brilliant thanks ... I'll do it when I change the oil and replace the push rod .... and hopefully the 3 x casings that will have been polished by then !!


Simon

JezzaPeach:
Hopefully if a bit is protruding you can grip it and draw it out. Mine was broken behind the plate with the hole in, the shorter piece had been put in back to front so the shaped end had peened the tip of the long section so it was too fat to come out through the hole.   >:(

SPR:
So ... all set today to swap the push rod / change the casings and refresh the oil / filter etc

Question ... if i have to get the pushrod out from the clutch basket side - is there a torque setting for the nuts when re assembling - I've looked but can't find one ?

Thanks

Simon

Bryanj:
Tight is the one, there is a generic for 6mm bolts but thats in the book and mine aint here

SPR:

--- Quote from: Bryanj on October 15, 2022, 09:12:17 AM ---Tight is the one, there is a generic for 6mm bolts but thats in the book and mine aint here

--- End quote ---

Thanks Bryan

Navigation

[0] Message Index

[#] Next page

[*] Previous page