SOHC.co.uk Forums > CB500/550
Stainless Steel 500 wheel & engine spacers
Oddjob:
Got the address now Steve, cheers.
I found the sprocket side spacer, forgotten I'd had it hard chromed along with the spindle and it was still on the rear wheel spindle where I left it, logical really.
It's 32mm length, 20mm bore, 38mm wide at largest point but steps down to 34mm, the step is 8mm. Has a very slight chamfer on the smaller end where it goes through the oil seal. About 1.5mm of chamfer.
Oddjob:
Well bugger me I've only gone and found the brake plate spacer as well. Got my lad bringing round my engine bolts from the other garage and hopefully the engine spacer will be threaded on the bottom bolt.
Anyway, dimensions
Length 45mm
Bore 20mm
Width 35 chamfers down to 28mm. Lip on edge of spacer 3mm on both edges
Laverdaroo:
Ive dug mine out for the 550 to send up to Max for copying also.
amx1992:
Awesome, cheers for that Oddjob and Roo, I will jump on the lathe Monday morning
Laverdaroo:
Posted today for you. Both rear’s and two frame ones. The dinky little one and the larger cotton reel type looking ones 4 total sent recorded
Sent from my iPhone using Tapatalk
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version