SOHC.co.uk Forums > CB500/550
Stand spring slack ?
Laverdaroo:
--- Quote from: K2-K6 on November 26, 2022, 03:56:49 PM ---
--- Quote from: Oddjob on November 26, 2022, 02:47:21 PM ---I'd remove it again, take a pic of it against a ruler and I'll see about comparing it with mine..
--- End quote ---
We'll all avert our eyes while this is carried out :o
Apologies for juvenile sniggering over here in "daahhhn saarff" ;D ;D ;D
Filth! ;D
--- End quote ---
JezzaPeach:
🙈
McCabe-Thiele (Ted):
I have measured my old spring it is 125 mm in length on the bench - just shy of 5" in old money.
I used a spring puller to fit my new one - it was close to the limit of my weakling biceps to hook it on that was with the swing arm fitted but no rear dampers - just made it a tad easier for an old man.
SPR:
--- Quote from: McCabe-Thiele (Ted) on November 26, 2022, 04:13:45 PM ---I have measured my old spring it is 125 mm in length on the bench - just shy of 5" in old money.
--- End quote ---
Cheers Ted - I'll try and get this one off tomorrow
McCabe-Thiele (Ted):
These things are a challenge to common sense - yesterday I realised I had not fitted the steering column bottom outer race - it will be interesting to see if I can fit it working upside down or if I need to remove the rear wheel, swing arm, stand and fit it with the frame upside down as I did on the 400.
I'm assuming your centre stand is the one you took off not a spare stand.
Any news when the "Eagle will Land" (Laverda) ?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version