SOHC.co.uk Forums > The Black Bomber Board
M10 DOME Cylinder NUTS HEX
mo goldie:
Hi everyone
well sorry about the confusion, what I meant was that the course threads are on the studs NOT the Nuts.
and it is a 1967 Bomber and it has the course studs as I said so it must mean then that they are the 1.50
pitch threads Not 1.25, which is what i got so don`t fit but they did fit the rear shocks so used two anyway ;D
but still looking for some 8 X 10 mm domes nuts then with a pitch of 1.50 ?
Cheers
Mo
AshimotoK0:
I will check my Bomber frame. https://www.accu.co.uk/dome-nuts/62138-HDN-M10-A4?uk_google_shopping=1&c=3&gad=1&gclid=Cj0KCQjwy4KqBhD0ARIsAEbCt6hwCPdYsf2Aj_vd9agaVRy-6knA51E5YzLffR5jbOoSvN7g3nuHC6oaAjfHEALw_wcB
mo goldie:
oh
am I right or wrong here..... is the 1.50 tread the course or the 1.25 thread ?
as they have some on Amazon and there chart say they are 1.50 pitch if they are the course thread I will get some ?
https://www.amazon.co.uk/YoiYee-Pack-M10-Dome-Nuts/dp/B0BXT7JVGN/ref=sr_1_8?keywords=m10%2Bstainless%2Bsteel%2Bdome%2Bnuts&qid=1698788361&sr=8-8&th=1
McCabe-Thiele (Ted):
The lower the pitch number the finer the thread.
I think of it as you need more turns with a fine thread to gain the same clamping effect.
Oddjob:
Try these.
Middletons are very good, usually polished with no visible surface markings.
https://www.stainlessmiddleton.co.uk/32956-metric-nuts-domed
Plus most 10mm nuts will be 17mm not the usual Honda 14mm, Middletons do the right spanner size.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version