SOHC.co.uk Forums > The Black Bomber Board
M10 DOME Cylinder NUTS HEX
mo goldie:
are ok thanks........... but just ordered the ones from Amazon they were 10 for £4.59
so will try them should be here tomorrow ;D
mo goldie:
hi
well that was a waste of time and Money they did Not fit From Amazon... so they are Not 1.50 they must be the 1.25 thread.
Just looked on what Oddjob sent the link for and it was Not clear...... is it 10 for £12.95 or for One ? :-[
Must be a walking bank I think ha ;D
mo goldie:
are here we go again ;D
just found a company called MrMegapack and got 10 X M10 X 1.25 pitch .....please be right this time my wallet can`t stand No more ;D
K2-K6:
--- Quote from: Oddjob on October 31, 2023, 11:11:10 PM ---Try these.
Middletons are very good, usually polished with no visible surface markings.
https://www.stainlessmiddleton.co.uk/32956-metric-nuts-domed
Plus most 10mm nuts will be 17mm not the usual Honda 14mm, Middletons do the right spanner size.
--- End quote ---
As an aside Ken, have you thought about exhaust studs in Titanium, like these https://www.ebay.co.uk/itm/114056592306 would be pretty corrosion resistant for bikes.
Oddjob:
I don't understand.
You clearly say in post 15 that the studs thread is 1.50. Yet you go and order 1.25 nuts in your last post from Mr Megapacks.
My link was to Dave Middletons metric domed nuts page, NOT metric fine as those are another page. So those will be 1.50. No idea where you got £12.95 from, they are listed in single price. A 14mm headed domed nut, the correct spanner size BTW for a Honda, are £1.98 each, to buy 8 will cost you £23.21 inc VAT and P&P.
Middletons are NOT the cheapest out there but they are excellent quality and most importantly they are the correct spanner size, 17mm headed nuts on the cylinder head may not even fit, especially if some sit in recesses.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version