SOHC.co.uk Forums > Anorak's Corner

Koso gauge RPM set up

<< < (5/8) > >>

McCabe-Thiele (Ted):
Is you rev counter designed to work with electronic ignition the switching signal profile might be unsuitable.

As you are dealing with an inducted circuit it might be possible to dampen it. Electronics is not my forte.

DomP:
It says its suitable for both, I think it's reading around half the revs on setting 2 which is 1 rpm signal per 2 ignitions so u wonder if I change it to setting 4 which is 1 rpm signal per 4 ignitions

McCabe-Thiele (Ted):
Deffo try setting 4 then. 👍

DomP:
I'll give it a try later Ted.  So why don't they suggest connecting it up on the ignition side rather than from the coil I wonder, then again looking at the instructions I'm not surprised.

McCabe-Thiele (Ted):
Just a thought might be coil side for CB, other side for Electronic..

Navigation

[0] Message Index

[#] Next page

[*] Previous page