SOHC.co.uk Forums > CB350/400
Transmission countershaft 25mm lock washer fitment
Dolomite_:
Got it! The haynes manual parts diagram is wrong. It must be the 350f. Its showing the wrong gears. Looking at the parts list its 33t then 30t, the haynes manual shows 30t first that's why it wouldn't fit. Sorted!
McCabe-Thiele (Ted):
So what way round did it fit in the end?
Did you have the wrong sized gear on the shaft?
My Haynes manual does not show that photo?
Dolomite_:
The counter shaft in my haynes manual and the parts list https://www.dropbox.com/scl/fi/geanqsh7vy2m8ewyqncnl/400-4%20Part%20List%201975%20searcheable.pdf?rlkey=hqb1np807bko695nym500d9zo&e=7&dl=0 seem to be slightly different. The haynes manual shows part 250 being a circlip and not the washer.
It was the wrong gear, the haynes manual had a wider gear, putting the one listed in the parts list was a little thinner and allowed the washer to rotate into the grove and then washer with the bent splines slots in. Weird.
The haynes manual I'm using is CB400 and Cb550 fours.
McCabe-Thiele (Ted):
Easily done - when I dismantled my 400 as a complete novice I used a large Cable Tie to hold stuff in order as well as taking plenty of photos. I stored each shaft & gear in large individual Tupperware type containers or Zip Lock Bags squirted with oil to prevent rusting during storage.
Dolomite_:
Yeah, each shaft and what was on it was stored in separate containers. The order in the haynes manual just threw me.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version