SOHC.co.uk Forums > CB350/400

Damaged rear wheel washer and circlip - replacement part

<< < (2/3) > >>

McCabe-Thiele (Ted):
You will find the 400 Parts Book shows the Hub, washer & circlip as items 155 & 396.
The circlip fits on the hub as has been said see parts book downloadable on here.
155 is  70 mm i/d washer p/n 41202-286-000 washer
397 is a 69 mm circlip p/n 90665-286-000

I would be minded to find a NOS circlip if available - as has been said might have had a chain drop off or my thinking is  circlip was never seated correctly. Not sure if the rear drive rubbers could have started to fall to bits causing sideways pressure?

Steve at 400fourbits  has never sold me a bad used part - you need to e mail him for a price.

beemsquar:
Thanks guys.

So the 4 nuts in the diagram don't hold the sprocket on? It looked to me that way. I'm pretty sure the chain hasn't dropped and think it wasn't installed correctly.
I'm assuming it's not safe to ride then?

McCabe-Thiele (Ted):
I would say do not ride it until the clip is in place.
Easy enough to take the wheel out and check if there is any damage to the hub itself.

The four nuts hold the sprocket to the drive cushions in the hub, the circlip and washer hold the whole arrangement to the hub. Check the parts book to see the fittings.

McCabe-Thiele (Ted):
This firm do a 69 mm circlip.
.https://www.acorn-ind.co.uk/p/neutral/circlips/1400-0690-neutral/

Simply Bearings list a very close alternative at 69.01 mm.

.
https://simplybearings.co.uk/shop/All-External-Circlips/c4519/index.html?selection=External+Circlip

beemsquar:
Thank you. I'll check those links out.

Navigation

[0] Message Index

[#] Next page

[*] Previous page