SOHC.co.uk Forums > CB350/400

Condenser for points...HOLY MOLY!!!

(1/4) > >>

Mikep328:
From DSS - For ND points plate:
Part No
30250333004
30250-333-004
Price£26.47
(£31.76 inc vat UK)

Above price from the DSS USA site, not available on the UK site.  So two would be around £63 plus shipping.  Are these available anywhere at a REASONABLE price?  I don't object to paying for quality stuff (heck, I just bought a CB400 brake rotor that may or may not be useful but the price seemed reasonable for the product). £63 is an absurd price for a couple of capacitors.

Bryanj:
You should check the price of condensers!

That price is about the same as they were in late 70's so i would consider it reasonable.

If you need both points and condensers its cheaper to buy the complete plate at about £110

Mikep328:
Glad I don't REALLY need them at the moment.  I was shocked at the price AND at the fact that DSS doesn't carry them as a "usual" item. 

FWIW:   It wouldn't be hard to buy a couple of appropriately rated condensers (capacitors) and remote mount them but that's WAAAY too inelegant/shade tree for me to consider!  I do a lot of restoration of vintage valve (tube) hiFi gear so I'm pretty familiar with replacing capacitors and/or testing them with an actual capacitor tester that, in addition to capacitance, tests leakage at rated voltage; multimeters can't do that.  A capacitor can show correct capacitance on a multimeter but fail totally when system voltage is applied.  A cap of around 2.5 uF and 630 volts DC would work fine for the application.   Here's one that might even fit on the points plate but the temperature max of 85C would be the factor that might require remote mounting.   https://uk.farnell.com/kemet/c4gamud4250aa1j/cap-2-5-f-450vac-5-pp-axial/dp/2808976 

AshimotoK0:

--- Quote from: Mikep328 on September 03, 2024, 07:17:11 AM ---Glad I don't REALLY need them at the moment.  I was shocked at the price AND at the fact that DSS doesn't carry them as a "usual" item. 

FWIW:   It wouldn't be hard to buy a couple of appropriately rated condensers (capacitors) and remote mount them but that's WAAAY too inelegant/shade tree for me to consider!  I do a lot of restoration of vintage valve (tube) hiFi gear so I'm pretty familiar with replacing capacitors and/or testing them with an actual capacitor tester that, in addition to capacitance, tests leakage at rated voltage; multimeters can't do that.  A capacitor can show correct capacitance on a multimeter but fail totally when system voltage is applied.  A cap of around 2.5 uF and 630 volts DC would work fine for the application.   Here's one that might even fit on the points plate but the temperature max of 85C would be the factor that might require remote mounting.   https://uk.farnell.com/kemet/c4gamud4250aa1j/cap-2-5-f-450vac-5-pp-axial/dp/2808976

--- End quote ---

Nice quality capacitor but value 10 times what is should be for a Honda ignition ! Should be more around the 0.25uF value.

AshimotoK0:
I often think of removing the inside of the Honda part and fitting one of these and then potting in epoxy. These caps are good for +125 degrees C It would look standard too. There is also a 0.22uF version.

[ Guests cannot view attachments ]

Navigation

[0] Message Index

[#] Next page