SOHC.co.uk Forums > Project Board

Tels CB550 project

<< < (5/13) > >>

McCabe-Thiele (Ted):
I had that issue, the seal does not fit in the retainer IIRC but as you say the cover plate.
If you scroll down to the diagram you can see how the O ring and the seal in the outer cover plate keeps the water out.

I had this conundrum see P51 of my build below

http://www.sohc.co.uk/index.php/topic,28541.750.html

Nurse Julie:

--- Quote from: TezzerTel on December 07, 2024, 04:27:26 PM ---So I've rebuilt both my wheels and had some nice new Continental tyres fitted.

I looked through my removed parts box and found these. Can't remember exactly where they came from !! Do the fir on the headlight mounts?

--- End quote ---
They almost look like a home made attempt at top yoke 'D' washers 🤔🤔🤔🤔
It's all looking very good Terry.

TezzerTel:

--- Quote from: Johnny4428 on December 07, 2024, 05:27:43 PM ---That looks like a couple of butchered washers been home made for spacers or the like, as Bryan says not Honda parts. Bike is looking very good though, nice work. Some lovely RC aircraft in the background too!😜

--- End quote ---

Yes I've been building and flying RC aircraft for a few years now. If you think old Honda's are expensive try RC aircraft  :o

TezzerTel:

--- Quote from: McCabe-Thiele (Ted) on December 07, 2024, 05:44:18 PM ---I had that issue, the seal does not fit in the retainer IIRC but as you say the cover plate.
If you scroll down to the diagram you can see how the O ring and the seal in the outer cover plate keeps the water out.

I had this conundrum see P51 of my build below

http://www.sohc.co.uk/index.php/topic,28541.750.html

--- End quote ---

Thanks I'll have a read

TezzerTel:
Ok so the 'C' type washers are not standard so no need to worry about them! I think there was 1 on each side of something at the front so I think there were either on the indicators or headlamp fixings

Navigation

[0] Message Index

[#] Next page

[*] Previous page