Other Stuff > Misc / Open

Chassis plate - hammer in drive screw rivett size?

<< < (2/3) > >>

TezzerTel:
I need a couple of these for my project too. I think I think I drilled the old ones out and used a 1.5mm drill (0.060"). I'll try and measure the holes tomorrow

McCabe-Thiele (Ted):
Thanks for the link Bryan, I think I have a damaged new one that I kept with the correct sized drill bit, I was sent the rivetts by either you or Ken I think for my 400.

If I can find the damged one I'll try to measure the diameter and post it for reference as a starting point.

McCabe-Thiele (Ted):
The drill bit has no markings, it measures 2.13 mm / 0.083" on the shank.

My damaged rivett looks like it was 4'5-5 mm long / diameter 2.15 ?

Looking at the Accu site the closest is nose diam 0.083"/2.108 mm, thread length 3/16" / 4.763 mm

Accu says thats No2 3/16", £1.80 for 12 with postage that's £8.46

https://www.accu.co.uk

McCabe-Thiele (Ted):

--- Quote from: TezzerTel on December 06, 2024, 09:31:40 PM ---I need a couple of these for my project too. I think I think I drilled the old ones out and used a 1.5mm drill (0.060"). I'll try and measure the holes tomorrow

--- End quote ---

I'm sending you a PM.

Bryanj:
Thats one of the two sizes i bought Ted, the other was smaller so good chance you are correct

Navigation

[0] Message Index

[#] Next page

[*] Previous page