SOHC.co.uk Forums > CB500/550

Cush drive retaining ring

<< < (2/2)

exvalvesetdabbler:
If it's going in where it was previously staked it will be a tight fit anyway even with a new ring.  I just tightened it up and put a discrete center punch mark on the ring and hub to keep an eye on it. Hasn't moved in 20 years.

I'm referring to the wheel bearing retainer rings above.

Regards
Dave

Murf:
Thanks for all the advice, I am probably not going to stake it when I do put it back, however that has been delayed for a bit, while I had it off I noticed that the wheel bearings had a bit of a notchy feel so decided to get some new and change them. Well why not!  at this point I have just about changed everything anyway!!!. ☹️ just a few more ££££ down the money pit,  it’s either 😂or 😢. 

Bryanj:
Translation of Honda from Japanese to English is £££££££

Navigation

[0] Message Index

[*] Previous page