Other Stuff > Desperately Seeking!!
400/4 engine bars
Bryanj:
The bolts are not a problem when fitting thecbars, its if you use them after taking the bars off because they are longer
Coppertop1234:
Yes i could see that been an issue and an easy mistake to make.
McCabe-Thiele (Ted):
Not really looked at the design before, they look neat.
The ones on my Superdream were not shaped & sculptured like those.
Otis:
--- Quote from: Coppertop1234 on September 17, 2026, 05:26:18 PM ---Thanks to Dave Engine Bars - all Fitted
I took care to make sure the bolts did not touch the engine casing by filing 2 mm off both bolt and also nut so there is still a gap to casings
They will look better when out and about on pics
here is a few from in the garage
--- End quote ---
Now that is exactly what I would like to have for my 350 Four.
TrickyMicky:
I didn't realise that design was still available, I had similar on my 1972 750
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version