SOHC.co.uk Forums > CB750
Keyster carb kit
RGP750:
Hoping for a press of the starter early May.
barring any more problems.
I'll report back
Lobo:
I used Keyster for a complete rebuild of my 750 K2 carbs in 2012 and so far have no complaints. It starts fine, idles smoothly & pulls uniformly through the RPM range. Balancing the carbs etc all straight forward enough. Not really done a great deal of miles, but the plugs look fine so far. (all settings by the book)
For sure would have preferred OEM.... but due the price was prepared to try the gamble. Think it paid off...
Bitsa (Ralph Wright - RIP):
I know this may sound stupid but recently I have seen lots of carb kits popping up all over the net.Some say made in Japan is that just a sales pitch to make you believe cos there Japanese they must be the dogs.Where and who make the infamous keyster kits.
Saw a set on A French site damm good price so emailed him asking who's make and got back short and simple Japanese.What do you all think on this?
Cheers
Bitsa
Norniron:
I bought a set from cruzinimage,an ebay seller from japan and they were fine.cheap too
RGP750:
I saw the cheap ones on ebay but looked at feedback and a couple of negatives
as "out of tolerance" so thought i'd go the David silvers route ,3 times the price,
but thought they would be fine.On advice putting original bits back in.this weekend.
Taking barrels for checking tomorrow, hoping to get away with a hone,
Any clues for new rings,other than the obvious. :(
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version