SOHC.co.uk Forums > CB750
Keyster carb kit
Bitsa (Ralph Wright - RIP):
I dont think it has anything to do with the jet size cant remember what its called but its the bit in the centre of the carb that the needle goes up and down in and the needle taper sticks in it.
Cheers
Bitsa
RGP750:
I know from memory it's longer than the original.
I'll check needle length/diameter when i get home
and see how it compares with original.
I'll report back later.
Rich
RGP750:
checked Keyster against original and find everything i can check within .002".
heights,position etc.
Could there have been an issue that has been resolved?
Do i put the old stuff back in or take a chance and maybe have to take the carbs off
when i finish the rebuild.
Decisions Decisions.
BigAl (Alan):
Hi Rich,
Possible the problem has been resolved after complaints. If you PM me with your address, I can send you the 'keyster' 4No. needles/jets so that you can make a comparison. From memory the 'keyster' needles where much thick that the Honda needles.
Alan
philward:
Just built my K2 carbs up with Keyster parts - didn't mic them up but next to each other they looked same length. They are in now so wont know until start up and that's ages off - when Silvers gets some repo exhausts in stock!
Phil
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version