It has arrived!

[JustcallmeMrT]

I've spent 3 weeks badgering the PO for those.  They are now safely in my possession and ready for a good clean!

[Trigger]

Did you get the lever springs off him as well???

[JustcallmeMrT]

Indeed I did.  All parts seem to be there.  I can't say I wasn't worried.  Now all I still need to get from him is the original rear spoked wheel.

[JustcallmeMrT]

Not the nicest condition but I'm optimistic.

[Trigger]

They will clean up nicely in a ultrasonic cleaner.

[JustcallmeMrT]

I have access to an small ultrasonic cleaning tank at work.  Any suggestions as to what type of cleaning fluid I should use to get these clean? 

[Trigger]

Just had a look at the one i use and it just says Ultrasonic Engine Part. Aluminum safe/ use between 50-80 degrees.

[JustcallmeMrT]

There is one on ebay with the same description, will give it a try.

[Trigger]

I get mine from Woburn chemicals that is the nearest to me.

[tom400f]

Indeed I did.  All parts seem to be there.  I can't say I wasn't worried.  Now all I still need to get from him is the original rear spoked wheel.

Are you paying for the bike in installments as well ?

[JustcallmeMrT]

Indeed I did.  All parts seem to be there.  I can't say I wasn't worried.  Now all I still need to get from him is the original rear spoked wheel.

Are you paying for the bike in installments as well ?

I wish I were....

[JustcallmeMrT]

Can anyone point me in the direction of a 'how to' for removing individual carbs from the assembly?  There looks to be more than just screws and bolts involved so figure I should do some homework.

[JustcallmeMrT]

Finally, some before and after shots!

[Trigger]

You should of taken the tubes out before you put them in the tank. Why would you want to take the bank apart??

[matthewmosse]

Inpressive. carbs are a swine to do, fiddly little things.