SOHC.co.uk Forums > CB750
Replacement bars?
bike-pusher:
If one were considering buying a US-spec SOHC CB750, and wanted to replace the US cowhorn bars with UK-spec ones (K6, etc), where would one start looking? Pattern items quite acceptable. Dave Silver doesn't seem to list them, and someone must make good quality replicas, I'd have thought?
hairygit:
I.E. spec 400/4 bars will fit, I had a set on my 750K2 & 750F1. They are easily available from DSS, fit fine, and are about half an inch narrower than original 750F1 bars, internal cables etc. Incidentally, the 400/4 switchgear also fits 750F1
Sent from my GT-S5839i using Tapatalk 2
AshimotoK0:
I think they are pretty rare. I got got a NOS set spare with my 750K0 and sold them BIN for 30GBP, never sold anything as quickly on eBay, probably less than an hour after listing.
I tend to buy most stuff from eBay Germany now, too many bad deals in the UK. You could ask this guy, he speaks really good English and you couldn't wish for a more genuine trader. He usually list things BIN and best offer (bit like DK) As he says 'rubbish goes straight into the skip' His name is Frank.
http://stores.ebay.de/jap2wheelz?_trksid=p2047675.l2563
Cheers .. AshD
Bryanj:
I don't remember anybody doing pattern bars with the holes for the wires and they all seemed thinner than Honda ones so to my mind the only safe way to use pattern is cut/notch the switches to bring the wires externat
bike-pusher:
SOHC CB750 runs wiring through the bars? My F2 doesn't. Hm. Oh, well, I have plenty of 400F bars, so they might do the trick. I wanted something with a sloight raise, though, but not as drastic as the US cowhorns.
Navigation
[0] Message Index
[#] Next page
Go to full version