SOHC.co.uk Forums > CB500/550

How many rattle cans?

<< < (2/4) > >>

Green1:
Don't say that James it will go to his head

Trigger:
No problems. Have shared it before. Good stuff the Simoniz in all its paint range. MR Holts if your watching please send me a FREE Trade pack ;)

JustcallmeMrT:
Thanks Trigger,  really appreciate the info.  I'm more than a little concerned about my ability to take the engine to pieces to paint and then put it all back together.  I read a few posts where guys have painted the engine assembled, then cured the paint using a heat gun and monitoring temp with an infrared thermometer.  I know this wouldn't be ideal, but is it reasonable?  Can an amateur really tear this thing to pieces without a lot of specialist tools? 
The doubt and fear creep up on me with this job...

Trigger:
The engine will need the basic's. ie, cam chain, primary drive chain and if the bike has been sitting a while, the valve stem seals would of gone hard and the head gasket may leak. I have known lots of people that try to get the engine looking good without doing the basics and regretted it with oil coming out of seals and mucking up there nice paint job.
Have sen you a mail showing engines that have been finished in SIMVHT31C.

Bitsa (Ralph Wright - RIP):
Mr T
Wish I could advise you but I have never painted one.While I like the bike to look good I also want it to look something like its age.Saying that boy they do look good when done.As for taking it apart do you need to?How many miles has it done would it hurt to take it apart and thoroughly clean her out and rebuild with shells,rings and chains.Until you pull her apart you wont know.I think the only tool apart from the obvious is the clutch tool.With me I have always stripped them down and replaced parts that I know to be past their sell by date as I do not trust PO who are mostly full of crap.All they want is to sell it.
Best of luck
Bitsa

Navigation

[0] Message Index

[#] Next page

[*] Previous page