SOHC.co.uk Forums > CB500/550
Bushes - I need a "how to" guide
Trigger:
--- Quote from: Green1 on December 17, 2014, 08:27:49 PM ---Ha I did something right that's were I got mine from.
Mick
--- End quote ---
I have known Frank for years. Met him when i lived in Germany. Good old boy ;D
hairygit:
Yes, soak them in oil overnight, phosphour bronze is porous and will absorb oil, always a good way to start their working life. Lucas and various others use p/ bronze for bearings/bushes on starter motors, and they always pre soak in oil before fitting, and remember how long they last without any further lubrication:))
Green1:
Oh well I'm sure mine will be fine I grease them every 1000 mile or so.
Mick
UK Pete:
This what i did as you tighten the nut it pushes the small socket against the bush and out through the large socket
The swingarm ones need a bit of heat and are buggers to get out
pete
Bitsa (Ralph Wright - RIP):
Yup seen that afore and also seen when re fitting a vice with covers just wind them in
Cheers
Bitsa
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version