SOHC.co.uk Forums > CB350/400

Is this what the inlet manifolds should look like?

<< < (2/5) > >>

Drew400:
Thanks again Trigger.

Cheers, D.

boilermaker1:
 small screw (for balance tubes) , Is on the engine casting facing up, not on intake manifolds

Drew400:
They are indeed... my screws are already in place pending fitting of these manifolds. Cheers, D.

tom400f:
Drew mine is a late model but the carb rubbers have, er, 1 2 3 4 on them. See pic.

Have you looked closely?

steven400/4:
two rubbers should have one and 3 on and two should have 2 and 4 on the number goes at the top 1 at the top on n/s of engine 2 next to it and so on  so on

Navigation

[0] Message Index

[#] Next page

[*] Previous page