SOHC.co.uk Forums > Project Board
f2cafe racer
yozzer74:
Found this it mentions that he didn't use the notch pins in it .
yozzer74:
Ordered missing parts I need & o rings .been cleaning gasket surfaces up and noticed one of the cylinder sleeves as a slight bit of damage on it .making it sit higher than the sealing surface .do I need to get it skimmed or would I be ok trying to sand it down ?? [ Guests cannot view attachments ] [ Guests cannot view attachments ] [ Guests cannot view attachments ]
Bryanj:
Just carefully drawfile and wet n dry
yozzer74:
Just taken it back to machine shop .he's going to check with gauge if rest of its ok he say he will just file it up .
Coppertop1234:
Just been and seen Yozzers project in the flesh - its looking excellent!! and is a credit to your the detailing you have in your design
Keep up with the postings Yozzer - Spring will soon be here.
If you need a carb sync (if you don't have one) when your ready give me a mail and I pop it up
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version