SOHC.co.uk Forums > CB750

My Us K6

<< < (2/2)

Bryanj:
Special tool to undo the clutch nut but that is all

Bitsa (Ralph Wright - RIP):
On my k6 either of these switches work the first I think is f1 the second is replica k2 the only differences I know of is the red markings for lights and last is clutch tool
Cheers
Bitsa

MeilakJ:
Thanks for the info to all!!

All my reading from this site has been use full. I have been busy dismantling the whole bike !! .Quite a challenge but i have enjoying everybit !! I am very glad to find that the bike is all there and all parts are they left from the factory !!

Today I have taken the engine out and when I removed the chain I noticed that the sprocket seem to be loose, not so tight in place is this normal ? would it need replacing ? Any comments would be appreciated !!

Tonight I will start ordering parts hopefully. Will have to go from Germany cause of the high Euro to GBP rate !!

Cheers

Bryanj:
If yours has the locking plate with two 10mm spanner size bolts it is not supposed to be a tight fit on the spline

MeilakJ:
Yes That is how it is with the 2 bolts . Thanks for the info.

Navigation

[0] Message Index

[*] Previous page