SOHC.co.uk Forums > CB750

Fork advice please

<< < (3/5) > >>

philward:
I would check on CSML for compatability of the internals (using their schematic diagrams) because from memory (when I was sourcing bits for my original basket case), the lower internals are different so if you're using internals from the earlier (upto early k2) they may not fit - worth a check
Phil

Mike on a bike:
GJ, I might take you up on that. Do you know what year they are? I shall do some homework on that.

Phil, pardon my ignorance but what/who is CSML?

philward:
Mike

Its a Dutch 'Dave Silver' but it has all the parts schematics - Here's the link - http://www.cmsnl.com/honda-cb750k2-four-european-direct-sales_model14369/partslist/

Phil

ginger_jim:
Hi Mike, TBH I don't know  :D

I bought them from Bitsa on the off-chance that I could use the fork tubes which luckily I was able to use with the standard bottoms.  Only difference is that the tubes were about 7mm shorter than standard so the old girl should steer a bit quicker, not that ive noticed any difference.

Let me know if you need any more photos.

Cheers

Bryanj:
I think that even if the internals vary the bottom allen screw that holds it together is the same so they should fit, you need to use the internals that go with the steel tubes to get the lengths correct

Navigation

[0] Message Index

[#] Next page

[*] Previous page