SOHC.co.uk Forums > CB750
Fork advice please
ginger_jim:
Good day to you sir :-)
You mean the damping rods etc?
I can send Mike them as well.
Bryanj:
The damping rods and springs yes but they should stay with the relevant fork tubes due to length and end machining differences
Mike on a bike:
My main problem here is that I have 6" over forks on my bike and I have no idea how the internals are set up.
As a little Spanish man once said......."I know nothing...K"
Bryanj:
Hopfully what thay have done is just fit a 6 inch piece on top of the spring.
Main difference is very early ones had a long threaded rod up the inside that joined the top nut to the damper and if it wasn't there or unscrewed from the top nut the sliders fell off if forks lifted too high. Later ones had a reducing plug welded into the bottom of the steel tube and the damper will only come out of the top
Mike on a bike:
GJ, could you possibly take a picture of the other side of the forks so that I can see the mudguard fixing points please. :D
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version