SOHC.co.uk Forums > Project Board
1977 CB550
Valentinik:
Thanks trigger, I've got some blue hylomar so will go with that if it's suitable.
Mike
Bryanj:
Don't forget to put the primary gear inside the chain first
Valentinik:
Thanks for the pointers both, the kickstart is already assembled in the bottom case. I have however forgotten to order the cap for the clutch shaft.
The local main dealer can't get them in stock and they are a week special order from DS so il have to wait for it to arrive before I can assemble the cases. >:(
Valentinik:
My oil seal arrived today so I got on with building the engine cases back up.
I got both cases mounted together and the primary installed:
I have also installed the gear shift:
A concern I have though is, there seem to be 2 small issues with the casting either side of the shaft, shown in this picture. Is this something I need to be concerned about?
Mike
Bryanj:
I seem to remember that the line on the bearing should be horizontal with the joint line so are you sure it was on the locating peg properly?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version