1
CB350/400 / Re: Clymer 350-550 handbook.
« on: December 09, 2020, 03:32:35 PM »
Sorry missed this is it still available.
Neil
Neil
Try our re-instated info resource - "Aladdin's Cave" (Main menu)
- sorry it's taken so long to fix 
|
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1] 2
1
CB350/400 / Re: Clymer 350-550 handbook.« on: December 09, 2020, 03:32:35 PM »
Sorry missed this is it still available.
Neil 2
CB350/400 / Re: DSS replica seat« on: October 02, 2020, 12:20:12 PM »
I had the same seat from DSS, I cut about 7mm off leaving about 6mm of rear rubber block and it's now latches well and looks right.
3
Out & About / Re: Out and about 2020« on: September 23, 2020, 08:18:47 PM »
Try bellengineering.co.uk they do new pumps, I have never used them but they are freelander specialists, I have a Freelander 2 myself, so I would be interested to see how you get on.
4
CB350/400 / Re: Had enough« on: June 01, 2020, 12:30:26 PM »
Andy
Do post your progress on your CB900 project, as I have a CB750FA which I have had for 30 years and I am am about to start looking at getting back on the road in the next few weeks, if you haven't already done so take a look at the cb750c.com forum loads of stuff on there about our bikes, and I have got a set 900 carbs if you need them. 5
Misc / Open / Re: David Silver sohc 4cyl anniversary day« on: September 29, 2019, 10:31:27 PM »
Great to meet you all, and it's good to see these old bikes being used as they were intended, 492 miles is a good run out, That's more than I've done all year on my 400. Note to self I must get out more.
6
CB350/400 / Re: Clock refurb« on: September 11, 2019, 10:34:38 AM »
Superb job, that's spurred me to finish mine, I have also been using LED's and they are bright, I have tried several types but not found the perfect one yet, if you find any would you let us know.
Neil 7
Project Board / Re: 1975 400/4 project« on: September 03, 2019, 10:14:33 AM »
Nice bike that, the paintwork looks lovely and glossy
8
New Member Introductions / Re: Newby from USA« on: September 03, 2019, 10:06:28 AM »
Welcome brewsky
I like the photos looks more like a bank than Motorcycle shop, certainly different to the bike shops we have here. 9
Out & About / Re: Best bike, best passenger!« on: August 02, 2019, 03:10:08 PM » or the Isle of Dogs
10
CB500/550 / Re: Crich Tramway event This Year« on: July 08, 2019, 11:12:41 AM »
Great day out, nice to meet everyone, the blue 250 was our favourite too, And hopefully I and Mrs Windy will be back next year on our 750F.
11
CB350/400 / Re: f2 colours« on: May 24, 2019, 05:26:55 PM »
Hollywood red by collection 7 day wear from boots is a good match.
12
CB350/400 / Re: clutch help« on: May 17, 2019, 11:02:01 AM »
Thanks for the pictures Graham and for all the comments, I think the rivets look the same flush with the surface, so I will clean and put it back in.
Cheers Neil 13
CB350/400 / Re: clutch help« on: May 16, 2019, 07:25:04 PM »
Has someone got a picture of the inside of the clutch outer, so I can see what the rivets should look like.
14
Out & About / MCN show at the weekend« on: May 16, 2019, 03:39:03 PM »
Hi
Is anyone going to the MCN show at Peterborough at the weekend (used to be the BMF rally) Ill be there on Sunday. 15
CB350/400 / clutch help« on: May 16, 2019, 03:29:15 PM »
Hi,
Looking at the clutch on my 400 today, theirs the usual play between the gear and basket which I am not bothered about, but what worries me is the basket has scoring/grinding marks near the rivets on the inside, there not deep only just detectable by finger nail, should I be worried, has someone opened it. I've tapped the rivets and their not moving. hopefully the photos show it.
Pages: [1] 2
|