SOHC.co.uk Forums > CB500/550
CB550k1 US Import - UK registration
McCabe-Thiele (Ted):
--- Quote from: Oddjob on December 23, 2022, 02:18:35 PM ---
After perfecting this method Ted found that he was quite proficient at doing Prostate exams and now works for the NHS as a freelance poker.
--- End quote ---
Ah the finger of fudge test - lovely.
juitz:
Hello all,
Hope everyone had/is having a nice holiday break.
Sorting out transmission shafts and found a roller bearing cage that I can't identify where it's from?
I have the 20mm and 22mm roller bearings already sorted. Can anyone point me to where this 28mm unit belongs?
Trigger:
--- Quote from: juitz on December 27, 2022, 01:46:07 PM ---Hello all,
Hope everyone had/is having a nice holiday break.
Sorting out transmission shafts and found a roller bearing cage that I can't identify where it's from?
I have the 20mm and 22mm roller bearings already sorted. Can anyone point me to where this 28mm unit belongs?
--- End quote ---
looks to be from the primary shaft ;)
Laverdaroo:
Looks a bit like the cage that sits on one end of the shafts in the box, does it fit in that recessed cup you’re showing there Dave? It should do if that’s it. The other end is the conical oil feed that rotates. Not sure if that’s the right terminology or not. Do those rollers come out of it and sit loose?
I have a pair of spares if you need.
Sent from my iPhone using Tapatalk
juitz:
Hmm, well I thought I already had the two bearings needed for the countershaft and primary shaft?
The cage in the middle doesn't fit into either housing 😕
OK figured it out, it's the needle roller bearing for the starter gear.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version