SOHC.co.uk Forums > CB500/550

CB550k1 US Import - UK registration

<< < (68/115) > >>

juitz:
On the transmission countershaft, I took off the spacer ring but im not sure where it's supposed to sit once reinstalled?

Is there a reference mark? Or should it be pressed against the bearing once that is installed?

Oddjob:
Yeah, I'd butt it up against the bearing, once that's installed in the correct position of course.

juitz:

--- Quote from: Oddjob on December 27, 2022, 03:53:40 PM ---Yeah, I'd butt it up against the bearing, once that's installed in the correct position of course.

--- End quote ---

Ok, so my thought here is to install circlip, press bearing until it butts up against the bearing then press the ring against the bearing.

Bryanj:
Check in parts book to see if any O rings fitted

Oddjob:
If you look carefully you can see a ring around the shaft, that looks to be where it was sat originally. There is a small o-ring between the bearing and the collar, don't forget that.

Or ask someone to measure the distance it's sat from the end of the shaft.

Navigation

[0] Message Index

[#] Next page

[*] Previous page