SOHC.co.uk Forums > Project Board
Honda CB400NA Superdream - new money puddle.
Laverda Dave:
I think it's the flash on the camera Ken, its much darker than that in real life. The coil holder is a difficult part to plate apparently because its laminated the passivate drips out from between the laminations as its drying causing streaking (although Gary the plater has been in the ttrade for so long he doesn't get that problem).
McCabe-Thiele (Ted):
My M3 X5 x 0.5 mm brass washers arrived a couple of days ago, they are a perfect fit on my mixture screw fitting.
McCabe-Thiele (Ted):
My brother came over to help me fit the rear drive hub circlip yesterday, I could not press the chain ring down and fit the big circlip on my own. What a difference an extra pair of hands made. He actually come over to help me move some wooden shelving out of the rear bedroom ready for the new boiler installation next month.
Today I thought I could just fit the new genuine Honda Dust seal on the rear hub on my own. I've almost had it fitted twice for it to let go again.
Is there a trick to this or is it a case of needing another pair of hands holding one side in place whilst the assistant pushes the other half of the inner lip over the oversize washer ?
I started with a dry dust seal, then using Red Rubber grease, I've been closest to success with the use of grease.
Bryanj:
You need an army of trained spiders with mechanical aptitued Ted or just determination and luck
McCabe-Thiele (Ted):
--- Quote from: Bryanj on April 27, 2025, 08:06:55 PM ---You need an army of trained spiders with mechanical aptitued Ted or just determination and luck
--- End quote ---
As I have fitted new drive cushions I suspect I will need an extra pair of hands to press down on the sprocket, this gives a slightly wider gap for the lip to fit over the washer. It will have to wait for my brother to help me.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version