SOHC.co.uk Forums > Project Board

Honda CB400NA Superdream - new money puddle.

<< < (51/60) > >>

McCabe-Thiele (Ted):
Finally fitted the drive hub dust seal, two pairs of hands made the difference - thanks brother Paul. ( He isn't a Monk)

Both carbs now cleaned, assembled then attached to the pair of mounting brackets.

Next task will be fitting the rear wheel into the frame to check if the 500T swing arm is fully suitable. There will be an unknown drop in rear ride height

McCabe-Thiele (Ted):
Just a bit of an update since my heath issues have improved and Wendy's Stroke last April.
I'm planning to start work on the SD in the next few weeks, it will only be a few hours a week, I see it as a sort of home  respite from my new role as a Carer.

The 500T swing arm did not work out, yes it fitted but rear wheel was way off center using the original spacers. The longer arm length was also problematic impacting on chain length & ride height.

I had the original swing arm repaired by a member on the SD website, it fitted a treat with the rear wheel central to the rear fender, frame and wheels now fitted to frame.

PXL_20250524_190205750 by Macabe Thiele, on Flickr

Skoti:
Good progress, it's looking nice.
I always enjoyed riding the 400's so much nicer than the tiresome 250 version.

Hope it all comes together well for you.


I see you have the proper Jap Vessel screw drivers, always a pleasure to use quality tools.

McCabe-Thiele (Ted):
Well spotted on the tool front Skoti, I have a set of three.

hondarc166:
looking good ted do a bit at a time glad you are feeling better

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version