SOHC.co.uk Forums > Project Board
Honda CB400NA Superdream - new money puddle.
Oddjob:
Yes as it’s movable to a certain degree. Don’t forget, grease the bolts before fitting or you risk them bonding into place over time.
Still working on the Z1000, really enjoying getting my hand back in. Have to take frequent breaks though as I tire quite quickly but it’s getting better every week.
McCabe-Thiele (Ted):
At last I have the front wheel in place so the bike is stable again.
Currently cleaning the calipers, not sure if SS pistons are available for the early Nissin 400 Calipers.PXL_20260829_154437258 by Macabe Thiele, on Flickr
#
McCabe-Thiele (Ted):
I've dismantled the Calipers, one of the pistons needs replacing, my Superdrean 400NA has Nissin front brakes.
The part number looks like it is 45107-410-006, there is a SS version of this part number 45107-410-006P listed on ebay by Honda Classics (£24.95 with seal) as suitable for the CX500 amongst other Hondas, they do not list it for the Superdream.
I'll message them & see what they say, the piston measures as approx 35 mm long, 38.1 mm diameter on my Aldi Digital (Workzone) calipers.
The groove for the seal ring is full of muck on the inside shoulder edge, its like a sandy type sludge.
I'm sure there was a tip on the best way to clean these grooves, probably Ken or Bryan.
The caliper half would fit in my Ultrasonic Cleaner if that might help.
Oddjob:
Says suitable for the 400N on my viewing of the part. Buy it.
McCabe-Thiele (Ted):
Hi Ken, the one they list for the 400N shows in the details as 4 pistons in total, I suspect this is for a later caliper,
the p/n is 43107-MA3-006P, they are cheaper at £19.95 each, too small at 27 mm. I believe there was a later version that had smaller twin pistons on one side, not sure though.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version