Silicone rectifier rubber holder

[BigAl (Alan)]

Re - Silicone rectifier rubber holder, normally supplied with the main wire harness (example CB750F1)
Would any one know the part number for the rubber holder or a supplier
Picture attached...thanks in advance - Alan

[Oddjob]

Looks more like the clutch safety switch to me Al. See if the 550f lists them separately

[BigAl (Alan)]

Its part of the safety circuit which also involves the clutch switch
DS quotes the 'Rectifier silicone' part No. 31700-124-008 but there is no rubber holder listed on the DS site (CB750F1)
Fitted to a number bikes, but I have only seen them fitted on the main wire harness

Thanks for the reply

[Oddjob]

Have a look at 38301-KJ6-743 looks like it might be suitable

No forget that.

Maybe 38306-107-670

[BigAl (Alan)]

Just googled both numbers...they come up as a Honda indicator/winker relay

[Bryanj]

Do you think the small indicator mount might work 38306 092 670?
The diode one is not shown so must come with loom

[Oddjob]

The lower number shows as the rubber mount for me Al.

Try CMS

[BigAl (Alan)]

Thanks for the replies, but none of the above numbers came up on the CMS site

After a bit of a search part No. 32135-124-300 'holder, coupler' did come up on the CMS site...not in stock, but its a start.

Thanks again - Alan

[Bryanj]

I have found with CMS that you frequently have to look at a different model to get the part number as although its on the parts illustration the item number does not show in the parts list

[Bryanj]

The 38306 092 670? Number comes up

[Nurse Julie]

Al, is it just the part number you need or the actual part? I have a used one.

[ Guests cannot view attachments ]

[BigAl (Alan)]

Hi Bryan,  the number does come up 38306-092-670 description (suspension/winker) part. Supports a square type indicator relay.

Hi Julie, that's ideal. PM me and I will Paypal asap

I'm looking for 10 No. parts, will wait and see if CMS re-stock

Many thanks again - Alan

[BigAl (Alan)]

Thanks Julie, donation now made to the site

[Bryanj]

Al, i knew it was an indicator unit mount but from memory it is a similar size to the diode so i wondered if it might work for you, it is for the relay fitted to US bikes as against the UK ones

[BigAl (Alan)]

Hi Bryan,  the indicator (suspension. winker) is larger than the (holder, coupler)
I have attached a picture, the 2-way connector is 18mm across. once fitted in the rubber mount it's quite a snug fit to support the connector/diode