SOHC.co.uk Forums > CB350/400
carburettor
hondatri:
Thank all you Guys for info and Graphics. Done the job done today without any problems. I bought the Carb kit from Japan they were on Ebay. A very extensive kit ;D ;Donly thing I cannot figure out is they supply a Rubber seal about 3" in dia. Anyone know what it is for.
Bryanj:
If its a thin section "O" ring its a float bowl seal
Bodd:
--- Quote from: hondatri on January 03, 2015, 03:16:08 PM ---only thing I cannot figure out is they supply a Rubber seal about 3" in dia. Anyone know what it is for.
--- End quote ---
If it's like the one the arrow is pointing to it's as Bryanj says, the float bowl seal. [ Guests cannot view attachments ]
Clem2112:
After they are installed for a while they "mould" to the shape of the bowl so are a bot easier to re-fit.
I found that the petrol makes them grow slightly in length but an hour drying in a warm place shrinks them down to the right size !
Never needed to bond them in place either as they will stay in their groove as a rule !
hondatri:
Thats the one Guys thanks for the information All you guys on this site have been very helpful.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version