SOHC.co.uk Forums > Project Board
1971 CB500K0 Resto 3/71 VIN 1000896
AshimotoK0:
--- Quote from: Woodside on December 20, 2015, 11:51:11 AM ---Is the pan completely fubard. ...
Have you not a potion in your arsenal you could coat it with...to contain all the crud ..kind off gel coat to keep it contained .
.
I'm following this thread closely as I have a UK Registered k0 in bits and I'm considering what's the best route to take with it..I'm slowly collecting the parts and seeing how you are marching forward at an outstanding rate is tipping me to dig it out and start it. ...or at least piece it together ...
--- End quote ---
Great stuff if it's spurring you on. I was thinking of coating THe DK one in alumium powder filled epoxy resin on the foam side then glass fibring it. It's a freebie anyway now so nowt to lose I suppose. Sides are really solid. I guess a family of rodents peeing on it didn't help ;D
UK Pete:
Ash where do you get your alumium powder filled epoxy resin
pete
AshimotoK0:
--- Quote from: UK Pete on December 20, 2015, 02:24:29 PM ---Ash where do you get your alumium powder filled epoxy resin
pete
--- End quote ---
Make it myself :) . RS industrial 2-part epoxy kit mixed with aluminium powder .
UK Pete:
Could this be used for fin repair?
AshimotoK0:
Yes done it Pete. You drill 1 mm holes into the fin and bond in drill blank pins to act as reinforcement , then use the epoxy to bond the pins. Then use the putty you make from the powder and epoxy to build up the repair. Great on fins that are painted as standard. A bodge I know before someone shoots me down in flames ;D. If you want a bit to try , let me know. Got your mob no off Rich today , when's the best time to call?
Cheers Ash
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version