SOHC.co.uk Forums > CB750

front disc removal, twin disc cb750 F2

<< < (2/4) > >>

onethumb:
Hi hairygit, no worries my friend I'm trying to undo it, no hole on my axle but a 22mm on the sleeve side and 16mm open ended spanner on the other, its not left handed is it?
Its in the garage with wd40 soaking in.

this is a top forum.

UK Pete:
What i did with my stubborn one is to tighten the opposite side of spindle in the outside of the lower fork spindle clamp then with a decent spanner undo it, does that make sense
pete

hairygit:
No, it's normal right hand thread.

Sent from my X5 using Tapatalk

onethumb:

--- Quote from: UK Pete on December 09, 2015, 10:07:51 PM ---What i did with my stubborn one is to tighten the opposite side of spindle in the outside of the lower fork spindle clamp then with a decent spanner undo it, does that make sense
pete

--- End quote ---
It does thanks pete but forks have been removed and front suspension is at this moment in bits.
I'll leave it to soak overnight and try again tomorrow with a bit more heat.
Thanks again

tip top.

Johnwebley:
if it is really tight,put a bar through the hole in the end,and clamp in a BIG vice,

then use socket and LONG T bar to undo the nut,



good luck !!!

Navigation

[0] Message Index

[#] Next page

[*] Previous page