SOHC.co.uk Forums > Project Board

Honda CB400NA Superdream - new money puddle.

<< < (24/60) > >>

Bryanj:
Must admit to never having took one off Ted so thats a new idea to me

McCabe-Thiele (Ted):
I'm pretty sure the center stand has never been removed previously judging by the layers of road tar and grime on the area around both stands.

McCabe-Thiele (Ted):
The photo tells the story, the enlargement is almost round!


.PXL_20241123_103720742 by Macabe Thiele, on Flickr

Orcade-Ian:
You could press a short sleeve onto the new shaft with its O/D slightly larger than your wonky hole (so to speak!) then carefully file/dremel the hole so that the new sleeve is a good sliding fit in the frame.  With it clamped correctly it shouldn't go anywhere.

Ian

McCabe-Thiele (Ted):
My thoughts are in that zone, I used a cut plumbing olive as a starting point, not helped by it being to big in the first place.

Finding a suitable sleeve will be the hard part- not sure how they are listed on ebay - I'll scour my many boxes of bits first.

The shaft o/d is 18.65-18.85 mm according to UHSD site.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version