SOHC.co.uk Forums > Project Board

Honda CB400NA Superdream - new money puddle.

<< < (34/60) > >>

McCabe-Thiele (Ted):
It looks very similar to the 400 & 500 ones.

My worry is pulling off an end and then being unable to get it back together! I assume the gear end will be just a bearing, the other end is where the commutator/ brushes sit with wires from the outer housing involved. Sounds like a recepie for disaster, if it ain't broke don't fix it Ian?

I might look for a video.

Sesman:
Hi, Ted.

Take the leap. I did mine on the 550 and found it very straight forward without any special tools needed.

Orcade-Ian:
Your shout Ted
They are really simple to dismantle - release oil on threads and heads, a good fitting JIS bit in a ratchet and remove the 3 long screws.  Grip the flanged end in soft jaws and just pull the body off.  There are a few end float shims to rescue and Bob's your Dad's brother!

Would you want to leave all this (conductive) crap in there?

[ Guests cannot view attachments ]

The two brushes were both tight in their holders too.  This is an untouched (until just now) spare from a 400/4

[ Guests cannot view attachments ]

Ian

Craizeehair:
Agreed Ted, I did mine on the CB360 and found it very straightforward and definitely worthwhile , I could be wrong but can’t see it being very different and If I can do it, you certainly can.

McCabe-Thiele (Ted):
Just spent most of the night in A&E as Wendy has been unwell for over three weeks. Now they are saying it's Viral so no more antibiotics, just go back if she coughs up blood!

I'm seeing sense now, the starter motor will be dismantled, easier to paint when it's in bits. Two long screws now being soaked in releasing fluid. Pricey for brushes & new bolts at £30.00 if needed.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version